...
8 Here the Sync is complete.
9 Open Simulink Requirements by Reloading the set - for this first Close the already opened Set If the Set was already opened in the current MATLAB session as in Section 1a step 5, then it may need to be manually closed and reopened in order to display the changes: Right-click the set and select Close… as shown in Figure 12. We have found that simply closing the Requirements Editor or clicking the 'Refresh’ button will not be sufficient.
...
10 Re-open the Requirement Set in Simulink Requirements again.
...
8 In Simulink, the result is as follows where Maximum Mass requirement is removed. See 1a1 step 9 instructions on closing the set and reopening if the changes are not shown in the Requirements Editor.
...
1a3: Updating text of requirements on SYSML side, comparing, and synchronizing
...
7 Open Simulink Requirement Set, Maximum Mass is updated to 100 kg same as the SysML Model value. See 1a1 step 9 instructions on closing the set and reopening if the changes are not shown in the Requirements Editor.
...
1b: SysML package - Simulink requirement set connection
...
12 In Simulink Requirements the set Simulink_Requirements_for_MagicDraw.slreqx (get it here -SysML Models, Profiles and Mappings) is updated with Altitude. See 1a1 step 9 instructions on closing the set and reopening if the changes are not shown in the Requirements Editor.
...
...
1b2: Removing existing requirements from the SysML package, comparing, and synchronizing
...
7 The Simulink Requirement shows no Payload Data Rate requirement. See 1a1 step 9 instructions on closing the set and reopening if the changes are not shown in the Requirements Editor.
...
...
Note to user: Simulink does not allow us to change the name of the requirement set without changing the parent file name. Changing the Simulink requirement file name will change the path to the file, and orphan the Syndeia connection. This use case is not supported.
...