Objectives

The new learning objectives of this exercise are to compare and update state machine structures in SysML and Stateflow.

Preparation

This exercise assumes the student has

• Cameo System Modeler 18.0 - 19.0 (or MagicDraw with SysML plug-in) installed correctly on his or her machine with a valid license for use, and

• Syndeia 3.3 installed as a plugin for Cameo/MagicDraw with a valid license for use

• Syndeia Stateflow interface, correctly installed with a valid license for user.

• MATLAB/Simulink/Stateflow installed, licensed and available to the user,

• A local operating system network connection in the Syndeia Repository Manager

The user can use any local operating system network connection they have available. It is generally advisable to carry out these exercises in a non-production repository, a "sandbox", set up for training and practice purposes.

• Completed Exercise 12.1 and either still has the SysML model open or has saved and reopened it.

Exercise

1. We start from the Syndeia Tutorial Testbed.mdzip model at the end of Exercise 12.1. If you have not saved the connections created in this exercise, repeat the exercise. Save and close the Simulink model.
   
   

2. Modify the SysML state machine by adding a new state and two transitions, as shown in Figure 1.
   
   

   Open

   

   Figure 1 Cameo System Modeler showing ThreeStates state machine diagram after modification
   
   

3. From the Syndeia Connection Browser (Figure 2), find the ThreeStates connection, right-click and select Compare Source & Target.
   
   

   Open

   

   Figure 2  Syndeia Dashboard, Connection Browser tab
   
   

4. The Comparison Result tab should appear as shown in Figure 3.
   
   

   Figure 3  Syndeia Dashboard, Comparison Results tab
   
   

5. Back in the Syndeia Connection Browser (Figure 2), find the ThreeStates connection, right-click and select Sync Source -> Target (make sure Simulink model is saved and closed before updating). Re-open the Simulink ThreeStates.slx model and double-click the state chart symbol to see the updated states and transitions (Figure 4).
   
   

   Figure 4  ThreeStates state machine after first update.
   
   

6. Syndeia 3.3 can update SysML state machines from Stateflow. Modify the ThreeStates model in StateFlow as shown in Figure 5 by moving the outgoing transition of the Standby state from the On state to the FailState state. Save the StateFlow model.
   
   

   Figure 5  ThreeStates state machine after second update

7. Back in the Syndeia Connection Browser, find the ThreeStates connection, right-click and select Sync Target -> SysML.
   
   

8. In MagicDraw/Cameo System Modeler, observe that the Transition:[Standby -> FailState] has been created in the containment browser. Drag it into the state machine diagram to display it and the final result should be similar to Figure 6
   
   

   Figure 6  Cameo System Modeler showing ThreeStates state machine diagram after modification